The Blazer - Automatic Aspirating Maintenance System

Key Features
Reduces filter replacement
Reduces the wear and tear of the ASD
Stops the transport and lifting of vacuums and compressors
Reduces call outs caused by flow faults
Lowers the overall cost to maintain

Overview

This automatic aspiration maintenance system is highly effective in blowing the network of pipes clean. The system is installed right above the detector in the piping network and briefly blows pressurised air into the pipe in order to remove any accumulated dirt. The pulsating effect of the air that is pushed through ensures that even persistent dirt is stripped from the inside of the piping network and removed. Fine dust such as from cocoa, straw, animal foodstuffs or numerous other continuous processes involving the release of high levels of dust will be removed.

Another major advantage of The Blazer is that a programmable logic controller can be used to program when the blow-out takes place. According to need, this can be daily, weekly or planned in-between certain shifts, taking into account weekends. During the cleaning process, the aspiration system continues to function without any further intervention required.

The Blazer aspiration maintenance system has been developed with the aim of securing the proper performance of the aspiration system. A clean system has a longer lifespan and a positive effect on operational reliability and with that operation times. The risk of the detector issuing an alarm due to blockages and pollution in the piping network is reduced to a minimum as is the frequency at which the filters need to be replaced.

In order for The Blazer to perform properly it needs a minimum pressure of 4 atmospheres. In order to handle these pressure levels, the system uses high-quality valves. As in the case of the valves, a conscious choice was made for highquality A-brand parts for the development of The Blazer. Once The Blazer comes into operation, a cleaning cycle is started at the aspiration pipe that is connected first, depending on the number of pipes connected. The first channel is cleaned in accordance with an adjustable time after which the system switches to the second and, if present, the third and fourth aspiration pipes.

How It Works

Tech Specs

Article Number

Blazer 100: ETBU-100

Blazer 200: ETBU-200

Blazer 300: ETBU-300

Blazer 400: ETBU-400

Power

24 Vdc Nominal (18-30Vdc)

Current

515 -100mA

Housing

Steel, powder coated RAL 7035

Dimensions

380mm x 380mm x 210mm

(14.96 x 14.96 x 8.26 inch)

IP Rate

NIP66 (complies with NEMA 4)

Weight

Blazer 100: 13.7 Kg

Blazer 200: 15 Kg

Blazer 300: 17.3 Kg

Blazer 400: 18.6 Kg

Input Relays PLC

System Fault (NC) 10A/30Vdc

Output PLC

2x remote stop, 1 x remote start

Display

Alarm, fault and time

Compression Connection

1/2” bsp x 12 mm female connector

Buffer tank 500 liter, supply pipe diameter

At least 18mm at up to 50 meters

Air Pressure

4 – 8 bar

Air Consumption

4 bar, 100 liter per 17 sec.

8 bar, 250 liter per 17 sec

Compressed Air Quality

ISO 8573-1 :2010 klasse 1.4.1

Certification

VDS pending in combination with Vesda

Part Codes

22-500 The Blazer 100
22-501 The Blazer 200
22-502 The Blazer 300
22-503 The Blazer 400

Downloads

Datasheets

Contact Us